Rear 3-Point Seat Belt With Belt Tensioner, Assembly Overview

Rear 3 - Point Seat Belt With Belt Tensioner, Assembly Overview







1 - Belt
2 - Belt guide
3 - Connecting bar
4 - Idler roller
5 - Locating projection
6 - Anchorage point: Outer floor panel
7 - Bolt
- Tightening torque 55 Nm
8 - Bolt
- Tightening torque 55 Nm
9 - Belt reel/belt tensioner
- Removing

CAUTION: Observe the necessary measures when disconnecting battery.

- Disconnect battery.
- Remove rear bench seat.
- Remove rear seat backrest.
- Open convertible top compartment.
- Remove bolt - 8 -.
- Disconnect belt tensioner connector.
- Remove belt reel - 9 -.
- Remove bolt - 7 -.
- Unclip front belt guide - 2 - and detach - 2 -.
- Open connecting bar - 3 - on belt guide - 2 -.
- Pull belt - 1 - out of belt guide - 2 - and Idler roller - 4 -.

- Installing
- Plug in connector to belt tensioner.
- Screw belt reel - 9 - with bolt - 8 -.
- Feed belt - 1 - into idler roller - 4 -.
- Feed belt - 1 - into belt guide - 2 - with connecting bar - 3 - open.
- Close connecting bar - 3 -.
- Attach belt guide - 2 - at rear and press on belt guide - 2 - at front.
- Make sure belt guide - 2 - is engaged at front in side trim.
- Make sure outer floor panel anchorage point - 6 - is engaged in locating projection - 5 -.
- Screw outer floor panel anchorage point - 6 - with bolt - 7 -.
- Install rear seat belt in reverse order of removal.
10 - Latch plate







Disconnect connector for rear seat belt tensioner
- Disconnect connector - 3 -.