Rear

Rear 3-point Seat Belt With Belt Tensioner, Removing And Installing







1 - Belt
2 - Belt guide
3 - Connecting bar
4 - Idler roller
5 - Locating projection
6 - Anchorage point: Outer floor panel
7 - Bolt
- Tightening torque 55 Nm.
8 - Bolt
- Tightening torque 55 Nm.
9 - Belt reel/belt tensioner
- Removing


CAUTION!
When disconnecting the battery observe the necessary measures.


- Disconnect the battery.
- Remove rear bench seat.
- Remove rear seat backrest.
- Open convertible-top compartment.
- Unscrew bolt -8-.
- Detach connector to belt tensioner, see Fig. 2.
- Remove belt reel -9-.
- Unscrew bolt -7-.
- Unclip front belt guide -2- and detach.
- Open connecting bar -3- on belt guide -2-.
- Pull belt -1- out of belt guide -2- and guide piece -4-.
- Installing
- Plug in connector to belt tensioner, see Fig. 2.
- Secure belt reel -9- with bolt -8-.
- Feed belt -1- into guide piece -4-.
- Feed belt -1- into belt guide -2- with connecting bar -3- open.
- Close connecting bar -3-.
- Attach belt guide -2- at rear and press on belt guide -2- at front.
- Ensure that belt guide -2- is engaged at front in side trim.
- Ensure that outer floor panel anchorage point -6- is engaged in locating projection -5-.
- Secure outer floor panel anchorage point -6- with bolt -7-.
- Continue installing of rear seat belt in reverse order to removal.
10 - Latch plate

Fig. 2 Disconnecting connector of rear seat belt tensioner







- Detach connector -3-.