Fuel Rail With Fuel Injectors - Component Overview

Fuel Rail With Fuel Injectors - Component Overview







NOTE: To prevent damage to catalytic converter the fuel system must be bled after repair work on fuel distributor or on fuel lines. The vehicle must only be started after bleeding.


1 - Socket-head bolt -10 Nm
2 - Protective cap
3 - Retaining clip
- Make sure clip is correctly seated on fuel injector and fuel rail
4 - Intake manifold
- with Throttle Valve Control Module -J338-
- with Intake Air Temperature (IAT) Sensor -G42-
5 - Fuel injector insert - 3 Nm
- use fluid securing material D 000 600 A2 to insert.
6 - O-ring
- Coat with clean engine oil
7 - Fuel injectors
- Cylinder 1 Fuel Injector -N30-
- Cylinder 2 fuel injector -N31-
- Cylinder 3 fuel injector -N32-
- Cylinder 4 fuel injector -N33-
8 - O-ring
- Coat with clean engine oil
9 - Fuel supply line
- Tighten to 25 Nm
10 - Harness connector
- for injectors
- 4x.