Fresh Air Blower Control Module (J126) and Fresh Air Blower (V2), Removing and Installing

Fresh Air Blower Control Module (J126) and Fresh Air Blower (V2), Removing and Installing

Removing

- Remove glove compartment.






- Disconnect connector -A-.
- Remove lower "A-pillar" trim.
- Loosen cable ties -B-.






- Remove bolts -A-.
- Pull air conditioner slightly to rear.
- Carefully fold back floor covering.






- Press noise insulation mat aside until rear bolt -C- is accessible.
- Remove bolts -C-.
- Push noise insulation mat aside and pull Fresh Air Blower (V2) -D- out of air conditioner.

NOTE:
- The Fresh Air Blower (V2) contains the Fresh Air Blower Control Module (J126) as an integral component which cannot be replaced separately.
- When installing, pay attention to correct positioning of Fresh Air Blower V2 in air conditioner.

Installing

- Install in reverse order.