FWD

Parking brake cables (FWD vehicles), removing and installing
Removing
- Remove center console extension.
- Detach the underside panelling on the rear left and rear right and unclip the parking brake cables.
- Unhook the underside panelling on the left -approximately 8 bolts.
- Detach the inside of the underside panelling at the exhaust.
- Unhook the exhaust at the rear.





- Pull out retaining washer -1- and detach the parking brake cables at the brake caliper.

Note: Do not damage parking brake bellows when detaching and attaching.





- Unclip the brake line -2- from the retainer -3-.





- Unclip the parking brake cables -1- from the fuel tank (clip) -2-.





- Unclip the parking brake cables -3- from the retainer -1-.
The parking brake lever has to be removed and the mechanism reset before it is possible to install new parking brake cables.
Removing and installing parking brake lever, Refer to Parking Brake Lever, Service and Repair

Installing





- Clip on the parking brake cable as far as it will go.

Note: At the crossover point see circle -, cable -1- must lie underneath cable -2-.

- Clip the cable into the designated retainers.





- The clip loop on the retainer must be located between the two positioning rings-4-.
- Tightening torque for -2-: 25 Nm
- Secure the parking brake cables on the underbody and tank.

Note: Do not damage parking brake bellows when detaching and attaching.





- Hook the parking brake cable into the brake caliper and insert the retaining washer -1-.





- The cable positioning rings -1- must be located within the clip points on the retainer.
- Tightening torque for -2-: 25 Nm
- Attach the heat shields.
- Install center console extension.
- Adjusting parking brake.