Fuel Door Release Actuator: Service and Repair

Fuel Tank Lid Unlock Motor V155, removing and installing







1 - Motor for fuel tank lid unlock V155
2 - Locking pin
3 - Fuel filler flap






Removing
- Disconnect electrical connector.
- Loosen bolts - arrows - using Socket Wrench T10010, slide actuator - 1 - up and remove.







Installing
- Before installing actuator, emergency release - 2 - must be slid over the locking pin.
- Locking pin of actuator must move cleanly into closed fuel filler flap - 2 -.
- Clip in grommets - 1 -.

NOTE:
- To remove fuel filler flap, remove bolts - 5 -.
- Panel gap dimensions.
Tightening torques: 1.5 Nm