Up to Model Year 2005

Bumper crossmember (up to model year 2005), removing and installing







1 - Bolts
- 3 Nm
2 - Cross member
- Mount on impact absorber.
- Bumper cover, removing.
- Disconnect electrical connectors to signal horn.
3 - Supports
4 - Screw
- 26 Nm
5 - Impact absorber
6 - Pop rivet
7 - Signal horn
- To remove, drill out hollow rivet heads and drive out rivet shafts.
8 - Guide piece
- Removing and installing.







Guide piece, removing and installing

- When installing guide piece - 1 -, tighten bolts in the following sequence.
- Tighten bolt - 2 - first.
- Then secure brace - 4 - with bolt - 3 -.
- Tighten bolt - 5 - last.
2 - Screw (4 Nm)
3 - Screw (1 Nm)
5 - Screw (6 Nm)