01V, 5 Speed Automatic

Diagnostic Trouble Code (DTC) table

Note:
^ In the following all the possible DTC's are fisted by ascending order of DTC numbers. These trouble codes can be recognized by the Transmission Control Module -J217-. Then they are displayed on the Vehicle Diagnosis, Measurement and Information System VAS 5051 during scanning of the DTC memory content.
^ If faults occur only occasionally or if the DTC memory was not deleted after the fault was corrected, these faults will be displayed for a predetermined time as intermittently occurring faults go to Transmission Control Module (TCM) DTC Recognition.
^ If faulty components are displayed when the DTC memory is read, make an additional check of wiring connections to the components for a short circuit and open circuit.
Refer to Wiring Diagrams, Electrical Troubleshooting and Component Locations.