Selector Lever Cable and Locking Cable, Assembly Overview

Selector lever cable and locking cable, assembly overview





Notes:
^ Do not bend or kink selector lever cable.
^ Lubricate pull ring and ball socket with polycarbamide grease, part no. G 052 142 A2.

1 - Selector lever cable
^ Must not be kinked
^ Removing and installing
^ Adjusting

2 - Lock nuts - 12 Nm
3 - Boot
^ For selector lever cable
^ Fasten into bottom cover of shift mechanism





4 - Locking clamp
5 - Ignition/Starter Switch
^ With ignition key removal lock

6 - Locking cable For ignition key removal lock Must not be kinked Removing and installing
7 - Hex-bolt - 9 Nm
8 - Clamping screw - 13 Nm
^ For selector lever cable
^ To adjust, loosen by approximately 1 turn, do not fully remove





9 - Pin
^ for selector lever cable
^ To remove selector lever cable, pull plastic securing spring on shift mechanism slightly forward and push pin up only as far as necessary

10 - Retaining clip
^ for selector lever cable
^ Always replace

11 - Pivot
^ for selector lever cable to transmission

12 - Hex-bolt, 23 Nm