Headlamp Igniter Module: Service and Repair

Igniter For Gas Discharge Lamps -N195-, Removing And Installing

Caution high voltage!
Make sure to disconnect battery Ground (GND) strap before performing work on parts of High intensity gas discharge (xenon) headlights marked with yellow high voltage symbols.

Removing
- Remove headlight.







- Remove bolts -arrows- and retaining bracket -2-.
- Remove igniter -1- for high intensity gas discharge (Xenon) from headlight housing and disconnect electrical harness connectors.

Installing
Installation is reverse of removal, paying attention to the following:
- Check seal between igniter for gas discharge lamp and headlight housing.
- Install headlight.

Tightening torque
Igniter for gas discharge lamp to headlight: 1.2 Nm