Erasing Fault Memory (Function 05)

Erasing Fault Memory

NOTE: If DTC Memory cannot be erased, check DTC Memory again and eliminate fault

Requirements:
- DTC Memory checked
- All malfunctions corrected

After DTC Memory interrogation:

Implementing function "05 - Erase DTC Memory"

Indicated on display:


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -5-.

Indicated on display:


Rapid data transfer Q
05 - Erase DTC Memory


- Confirm entry with -Q-button.

Indicated on display:


Rapid data transfer ->
DTC Memory is erased


DTC Memory has been erased.
- Press the -> button.

Indicated on display:


Rapid data transfer HELP
Select function XX

NOTE:

Warning ->
DTC Memory not checked


- This message indicates an error in the test sequence.


Rapid data transfer ->
DTC Memory not checked


- This message indicates an error in test sequence.
- Follow test sequence exactly: First check DTC Memory, if necessary eliminate any faults, then erase DTC Memory.
- After erasing DTC Memory, implement End Output with function 06, switch ignition off and on again, then re-check DTC Memory.