Servotronic Solenoid Valve, Checking

NOTE: The Servotronic control module is installed under the rear seat on the right side.
- Remove rear seat bench.
- Disconnect harness connector from Servotronic control module.





- Set digital multimeter (Fluke 83 or equivalent) to measure resistance (ohms), and check between Servotronic control module harness connector terminals 8 and 11.
Specification: approx. 6-12 ohms
- If resistance is not as specified:
- Replace Servotronic solenoid valve.
Removing steering gear, refer to Replacement. Service and Repair