01N Transmission

^ The table lists the malfunctions that can be recognized by the Transmission Control Module (TCM) -J217-, and displayed according to their 5-digit Diagnostic Trouble Code (DTC).

^ Malfunctions are displayed on the scan tool in "Rapid data transfer" operating mode 1; when the scan tool printer is switched on, the malfunction and the corresponding DTC are also printed. The 5-digit DTC appears only on the printout.

^ If malfunctions occur only occasionally, or if DTC memory was not erased after malfunctions were repaired, the malfunctions are displayed with "/SP" and/or printed along with "sporadic DTC" on the print-out => Malfunction recognition. Refer to "On-Board Diagnostics II". On-Board Diagnostics II

^ If, when checking DTC memory, faulty components are indicated, check wiring for short or open circuits according to the wiring diagram, and check wiring harness connectors for corrosion before replacing the "faulty" components.

^ Do not disconnect harness connectors from any electronic components unless the ignition has been switched off. Otherwise, malfunctions may be stored in DTC memory as a result.

^ Generic Scan Tool = GST.