No Response From Selected Sensor, Tester In Position 6

1. Turn ignition switch to the Off position.
2. Disconnect appropriate wheel speed sensor connector. Front sensors are located near front shock towers. Rear sensors are located beneath rear seat cushion.
3. Connect ohmmeter to female terminals, then measure the resistance. Reading should be 0.8-1.8K ohms.
4. If readings are not within specified range, replace wheel speed sensor.
5. If readings are within the specified range, check continuity between wheel speed sensor and ABS control unit connector.
6. Bridge male terminals of wheel speed sensor connector.
7. Remove ABS control unit connector, then check continuity between bridged wheel speed sensor and corresponding terminals of ABS control unit connector.
8. If continuity does not exist, repair circuit for short or open.