Tracks 63 Thru 74

ECM (Engine Control Module) - Track 63-74:

COMPONENTS

N18 = EGR Vacuum Regulator Solenoid Valve
N80 = Evaporative Emission (EVAP) Canister Purge Regulator Valve
S27 = Fuse in auxiliary fuse holder (Engine Control I)
G108 = Heated Oxygen Sensor (HO2S) II
G39 = Heated Oxygen Sensor (HO2S)
N156 = Intake Manifold Change-Over Valve
J192 = MFI Engine Control Module (ECM)
Z19 = Oxygen Sensor (02S) Heater
Z28 = Oxygen Sensor (02S) II Heater
K - Wire Distributor For Data Link Connector (DLC); Terminal K
L - Wire Distributor For Data Link Connector (DLC); Terminal L

CONNECTORS

T1a = Wire Connector, single, in engine compartment, right
T1r = Wire Connector, single, in engine compartment, right
T2z = Wire Connector, double, white, in Plenum, Near Relay Panel (Data Link Connector)

GROUNDS CONNECTIONS

NOTE: Grounds connections are indicated on the diagram by a numeric code inside a circle.

17 - Ground connection, on intake manifold
83 - Ground connection -1-, in right front wiring harness
84 - Ground connection, in engine compartment right wiring harness
124 - Ground connection, engine block, in right front wiring harness

HARNESS SPLICES

NOTE: Harness splices are points inside a wiring harness where two or more wires are crimped and/or soldered together. Harness splices are indicated on the diagrams by an alphanumeric code inside a circle.

D9 - Plus connection (15, via fuse 27), in right front wiring harness