For/AFT Sender Unit, Adjusting

Fore/aft sender unit, adjusting

Note:
Sender units can only be adjusted when removed from motors. Sender units should only be adjusted when replacing motors or sender units

Work sequence

- Unbolt seat from vehicle
- Using seat adjustment switches, move seat to forward stop and rear height to upper stop
- Remove seat from vehicle

Fore/aft Adjusting Motor:

- Unbolt right rear seat height actuator from right seat frame rail (arrow)
- Remove fore/aft adjustment actuator from right seat rail
- Pull guard tube and driveshaft from fore/aft adjustment motor
- Remove sender unit from motor
- Connect ohmmeter between BL/G and R/BK wire of connector T3a (on sender)
- Rotate inner part of sender until ohmmeter reads 9.0K ohms
- Install sender on motor
- Install driveshaft, guard tube and right seat actuator