Sunroof / Moonroof Motor: Adjustments

Electrical drive, checking/adjusting

Checking




- remove cover to sunroof motor
- open sunroof 50 mm (2.0 in) to rear and then close
^ tab A on cable drive gear must align with hole B in motor cam

Note: When these points are aligned, the sunroof motor is in the 0 position

If motor is not in 0 position after opening and closing,
- adjust 0 position


Adjusting

Note: This adjustment can only be done with sunroof motor removed.




- remove sunroof motor
- disengage sunroof motor from drive gear by moving lever B in direction of arrow cast on motor




- insert hand crank or 4 mm inside hex wrench into drive pinion A
- turn drive pinion with crank or wrench until the pin on the sunroof stop switch (closed position) falls into the recess of the motor cam (arrow)
- engage sunroof motor to drive gear by moving lever in opposite direction of arrow cast

Note: In this position the tab on the pinion drive gear is aligned with the hole in motor cam.