Front Height Sender, Adjusting

Front height sender, adjusting

Note:
Sender units can only be adjusted when removed from motors. Sender units should only be adjusted when replacing motors or sender units

Work sequence

- Unbolt seat from vehicle and tilt back
- Using seat adjustment switch, raise front of seat to upper stop and forward to forward stop

Front Height Adjustment Motor:

- Unbolt front height actuator from left seat frame rail (arrow)
- Remove guard tube and driveshaft from front height adjustment motor
- Remove sender from motor
- Connect ohmmeter between BL/W and R/BK wires on connector T3b of sender
- Rotate inner part of sender unit until ohmmeter reads 9.0K ohms
- Install sender on motor
- Install driveshaft and guard tube
- Bolt front height actuator on left seat frame rail