Backrest Sender Unit, Adjust

Backrest sender unit, adjusting

Note:
Sender units can only be adjusted when removed from motors. Sender units should only be adjusted when replacing motors or sender units

Work sequence

- Using seat switch, tilt seatback to forward stop
- Remove seat from vehicle
- Remove seatback cover from seat (4 screws)

Backrest Adjustment Motor:

- Remove sender from motor
- Connect ohmmeter between contacts 5 (red wire) and 3 (BK/BL wire) of green connector on control unit
- Rotate inner part of sender until ohmmeter reads 9.0k ohms
- Install sender on motor

Note:
- Install sender so drive pin and retaining lugs engage corresponding slots on adjustment motor

- Install seatback cover