The MID Displays and HFL Message Do Not Go Away After Pressing the HFL Back Button

HandsFreeLink System Symptom Troubleshooting - The MID displays and HFL message do not go away after pressing the HFL BACK button

The MID displays and HFL message do not go away after pressing the HFL BACK button

NOTE: Check the vehicle battery condition first Battery Test.

1. Connect the HDS to the DLC.

2. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

3. Check for DTCs with the HDS.

Are there any DTCs indicated?

YES -

Troubleshoot the indicated DTCs.

NO -

Go to step 4.

4. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

5. Substitute a known-good HandsFreeLink control unit Service and Repair.

6. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

Are the messages cleared?

YES -

Replace the original HandsFreeLink control unit Service and Repair.

NO -

Replace the gauge control module Service and Repair.