Radiator Cooling Fan Motor: Service and Repair

Radiator and A/C Condenser Fan, Motor, and Shroud Removal and Installation

Removal

1. Remove the engine compartment covers Service and Repair.

2. Do the battery removal procedure Removal and Replacement.

3. Remove the battery base.

4. Remove the air intake duct splash separator.

5. Raise the vehicle on the lift.

6. Remove the front splash shield Front Splash Shield Replacement.

7. Disconnect the A/C condenser fan motor connector (A), and remove the harness clamps (B).

8. Loosen the A/C condenser fan shroud mounting bolts (C).

9. A/T model: Remove the harness clamps (D).

10. Disconnect the radiator fan motor connector (A), and remove the harness clamps (B).

11. Lower the vehicle on the lift.

12. Remove the coolant reservoir (A), then remove the A/C condenser fan shroud assembly (B).

13. Remove the upper brackets (A).

14. Remove the radiator fan shroud assembly (B).

NOTE: Pull up the radiator, then move the radiator fan shroud assembly toward the right side of the vehicle to allow for enough space to lift it up and away from the A/C condenser fan shroud assembly.

15. Disassemble the fan shrouds.

Installation

1. Assemble the fan shrouds.

2. Install the radiator fan shroud assembly (A).

3. Install the upper brackets (B).

4. Install the A/C condenser fan shroud assembly (A), then install the coolant reservoir (B).

5. Raise the vehicle on the lift.

6. Connect the radiator fan motor connector (A), and install the harness clamps (B).

7. A/T model: Install the harness clamp (A).

8. Tighten the A/C condenser fan shroud mounting bolts (B).

9. Connect the A/C condenser fan motor connector (C), and install the harness clamp (D).

10. Install the front splash shield Front Splash Shield Replacement.

11. Lower the vehicle on the lift.

12. Install the air intake duct splash separator.

13. Install the battery base.

14. Do the battery installation procedure Removal and Replacement.

15. Install the engine compartment covers Service and Repair.