The BSI Indicator Does Not Go Off, Or Does Not Come On

Blind Spot Information System (BSI) Symptom Troubleshooting - The BSI indicator does not go off, or does not come on

The BSI indicator does not go off, or does not come on

NOTE:

- If the system malfunctions, always check for DTCs with the HDS.
- If a DTC is stored, troubleshoot the DTC first.

1. Press the engine start/stop button to select the ON mode, then wait for 10 seconds.

2. Check that the BSI indicator comes on for about 2 seconds and then goes off.

Does the BSI indicator go off?

YES -

The system is OK.

NO -

Go to step 3.

3. Check for DTCs with the HDS.

Are any DTCs indicated?

YES -

Troubleshoot the indicated DTC(s).

NO -

Go to step 4.

4. Do the gauge control module self-diagnostic function Testing and Inspection.

Does the side BSI indicator blink?

YES -

Replace the BSI control unit BSI Control Unit Removal/Installation.

NO -

Replace the gauge control module Service and Repair, and recheck.