Seat Occupant Sensor: Service and Repair

Front Passenger's Weight Sensor Replacement

Removal

NOTE:

- Removal of the front passenger's weight sensors must be done according to Precautions and Procedures. Service and Repair

- The front passenger's weight sensors are part of the seat frame and must be replaced as an front passenger's seat frame assembly.

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the front passenger's seat frame/front passenger's weight sensor as an assembly. Front Seat Frame Replacement

Installation

NOTE:

- Be sure to install the harness wires so they are not pinched or interfering with other parts.

- The front passenger's weight sensor are part of the seat frame and must be replaced as an assembly.

1. Install the removed parts to the new seat frame/front passenger's weight sensor as an assembly.

2. Do the battery terminal reconnection procedure. Procedures

3. Clear any DTCs. Initial Inspection and Diagnostic Overview

4. Calibrate the ODS unit. ODS Unit Initialization

5. Confirm proper SRS operation: Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode; the SRS indicator should come on for about 6 seconds and then go off.