Tightening Torques and Sequences

Crankshaft Bearing Cap

Bearing cap bolts 74 N-m (7.5 kgf-m, 54 lbf-ft)
Bearing cap side bolts 49 N-m (50 kgf-m, 36 lbf-ft)






Main Bearing Selection

Crankshaft Bore Code Location






Main Journal Code Location






Replacement Bearing Table






Connecting Rod Cap

Measure the diameter of each bolt at point A and point B.
If difference in diameter is out of tolerance (0-0.1 mm or 0.004 in.), replace the connecting rod bolt.





Tightening torque 20 N-m (2.0 kgf-m, 14 lbf-ft)
Tighten further 90 °






Connecting Rod Bearing Selection

Connecting Rod Journal Code Locations





Connecting Rod Journal Code Locations





Replacement Bearing Table






Crankshaft Pulley
Tightening torque 64 N-m (6.5 kgf-m, 47 lbf-ft)
Tighten additional 60 °






Drive Plate

Tightening torque 74 Nm (7.5 kgf-m, 54 ft lbs)
Tighten the eight bolts in a crisscross pattern in at least two steps

Without SH-AWD






Oil Pump

Housing 12 Nm (1.2 kgf-m, 8.7 ft lbs)






Water Pump

Torque 12 Nm (1.2 kgf-m, 8.7 ft lbs)