Keyless Operation Does Not Work (LOCK, UNLOCK, PANIC)

Symptom Troubleshooting: Keyless operation does not work (LOCK, UNLOCK, PANIC)

Keyless operation does not work (LOCK, UNLOCK, PANIC)

NOTE: Before troubleshooting, check the B-CAN DTCs. If any DTC is indicated, refer to the B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A troubleshoot the indicated DTC(s) first

1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

2. Try to start the engine.

Does the engine start?
YES - Go to step 3.

NO - Go to the immobilizer symptom troubleshooting. Immobilizer System Symptom Troubleshooting (Without Keyless Access System)


3. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

4. Do the transmitter test. Keyless Entry Transmitter Test

Is the transmitter OK?
YES - Replace the immobilizer-keyless control unit.

NO - Replace the transmitter.