Manufacturer Code Charts: 158

VSA DTC Troubleshooting: 158

DTC 158: ECU Software Reprogramming

1. Update the VSA modulator-control unit. Testing and Inspection

2. Turn the ignition switch to LOCK (0), then turn it to ON (II) again, or select the OFF mode, then the ON mode.

3. Check for DTCs with the HDS.

Is DTC 158 indicated?
YES - Check for loose terminals in the VSA modulator-control unit 47P connector. If necessary, substitute a known-good VSA modulator-control unit, Service and Repair and retest.

NO - The system is OK at this time.