A/T Clutch Pressure Control Solenoid Valve B and C Replacement

A/T Clutch Pressure Control Solenoid Valve B and C Replacement

1. Disconnect the A/T clutch pressure control solenoid valves B and C connectors.
2. Remove A/T clutch pressure control solenoid valves B and C.





3. Remove the ATF joint pipes (A), O-rings (D), and gasket (E).
4. Clean the mounting surface and fluid passages of the transmission housing.
5. Install a new gasket on the transmission housing, and install the ATF joint pipes.
6. Install new O-rings over the ATF joint pipes.
7. Install new A/T clutch pressure control solenoid valves B and C.
8. Check A/T clutch pressure control solenoid valves B and C connectors for rust, dirt, or oil, and clean if necessary, then connect the connectors securely.