FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Acura >> 2007 >> TSX L4-2.4L >> Repair and Diagnosis >> Powertrain Management >> Transmission Control Systems >> Actuators and Solenoids - Transmission and Drivetrain >> Actuators and Solenoids - A/T >> Pressure Regulating Solenoid >> Service and Repair >> A/T Clutch Pressure Control Solenoid Valve A Replacement

A/T Clutch Pressure Control Solenoid Valve A Replacement

A/T Clutch Pressure Control Solenoid Valve A Replacement

1. Remove the air intake duct.
2. Disconnect the A/T clutch pressure control solenoid valve A connector.
3. Remove the bolts securing the ATF cooler inlet line brackets (B) from the transmission hanger (C).





4. Remove the mounting bolts and A/T clutch pressure control solenoid valve A.
5. Remove the ATF pipe (D), ATF joint pipes (E), O-rings (F), and gasket (G).
6. Clean the mounting surface and fluid passages of the transmission housing.
7. Install a new gasket on the transmission housing, and install the ATF pipe and ATF joint pipes.
8. Install new O-rings over the ATF joint pipes.
9. Install new A/T clutch pressure control solenoid valve A.
10. Secure the ATF cooler inlet line brackets with the bolts on the transmission hanger.
11. Check the A/T clutch pressure control solenoid valve A connector for rust, dirt, or oil, and clean if necessary, then connect the connector securely.
12. Install the air intake duct.
pro multis Credits:Operation CHARM About Operation CHARM