Brake Master Cylinder: Service and Repair

Master Cylinder Replacement

NOTICE:
^ Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
^ Be careful not to damage or deform the brake lines during removal and installation.
^ To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent.

1. Remove the cable clamps from the body.





2. Remove the access panels (A), then remove the front strut brace (B).





3. Remove the accelerator position sensor mounting bolt (C) from the strut brace.
4. Remove the reservoir cap and brake fluid from the master cylinder reservoir.
5. Remove the primary and secondary brake lines (A) from the hose clamp (B).





6. Disconnect the brake fluid level switch connector (A).





7. Disconnect the brake lines (B) from the master cylinder (C). To prevent spills, cover the hose joints with rags or shop towels.
8. Remove the master cylinder mounting nuts (D) and washers.
9. Remove the master cylinder from the brake booster (E). Be careful not to bend or damage the brake lines when removing the master cylinder.
10. Remove the rod seal (F) from the master cylinder, or brake booster.
11. Install the master cylinder in the reverse order of removal, and note these items:
^ Replace all the rubber parts with new ones whenever the master cylinder is removed.
^ Use a new rod seal on reassembly.
^ Coat the inner bore lip and outer circumference of the new rod seal with the Shin-Etsu silicone grease (P/N 08798-9013).
^ Install the rod seal onto the master cylinder with its grooved side (G) toward the master cylinder.
^ Check the brake pedal height and free play after installing the master cylinder, and adjust it if necessary.

12. Bleed the brake system.
13. Spin the wheels to check for brake drag.