Carrier Bearings: Service and Repair

TOOLS REQUIRED
- 07MAD-PR90100 Attachment, 45 x 55 mm I.D.
- Or Equivalent

BEARING REPLACEMENT

NOTE:
- The bearing and outer race should be replaced as a set.
- Inspect and adjust the bearing preload whenever the bearing is replaced.





1. Remove the tapered roller bearings using the bearing pullers.





2. Install the tapered roller bearings using a special tool and a press as shown. Press the tapered roller bearings squarely until they bottom against the case.

BEARING OUTER RACE REPLACEMENT (Torque Converter Housing Side)

NOTE:
- The outer race and bearing should be replaced as a set.
- Inspect and adjust the bearing preload whenever the bearing is replaced.





1. Remove the bearing outer race, 90 mm washer, and oil guide ring using the special tools.





2. Install the oil guide ring and 90 mm washer, then drive the outer race into the torque converter housing using the special tools.