Paint Mixing Application
Paint Mixing Application1. Primer or primer surfacer provides good support for the filler and surfacer, and is applied to the surface of the bumper face. Use a spray gun only to apply the primer or primer surfacer.
NOTE:
- Mix the paint, hardener and thinner in the correct ratio.
- Follow the paint manufacturer's instructions.
WARNING:
- Most paints contain substances that are harmful if inhaled or swallowed. Read the paint label before opening the container. Spray paint only in a well ventilated area.
- Cover spilled paint with sand, or wipe it up at once.
- Wear an approved respirator, gloves, eye protection and appropriate clothing when painting. Avoid contact with skin.
- If paint gets in your mouth or on your skin, rinse or wash thoroughly with water. If paint gets in your eyes, flush with water and get prompt medical attention.
- Paint is flammable. Store it in a safe place, and keep it away from sparks, flames or cigarettes.
2. Designated color of top coat
The paint is either 2-or 3-liquid type. Mix the pigment, additive and hardener in the correct ratio.
- Top coats for solid and metallic enamel base, and top coat clear.
- Mix the additive into the pigment in the correct ratio.
- Mix the hardener into the mixture of additive and pigment (3-liquid type).
NOTE:
- Follow the paint manufacturer's instructions.
- Excessive additive will retard hardening.
- After mixing, dilute with the specified thinner to attain viscosity for spraying.
Mixing of pigment, additive, hardener and thinner: