Torque Converter Clutch Solenoid: Service and Repair

NOTE: Lock-up control solenoid valve/shift control solenoid valve A must be removed/replaced as an assembly.




1. Remove the mounting bolts and lock-up control solenoid valve/shift control solenoid valve A assembly.
2. Clean the mounting surface and fluid passage of the lock-up control solenoid valve/shift control solenoid valve A assembly, and install a new lock-tip control solenoid valve/shift control solenoid valve A assembly with a new filter/gasket.
3. Install the bolts with the connector bracket and the clamp bracket, and tighten the bolts.
4. Check the connector for rust, dirt or oil, then reconnect the connector securely.