Pressure Regulating Solenoid: Service and Repair

1. Remove the ATF cooler hose (outlet line) at the ATF cooler line. Turn the end of the cooler hose up to prevent ATF from flowing out, then plug the line and hose.
2. Remove the ATF cooler line (outlet line) from the transmission housing.




3. Remove the mounting bolts and the A/T clutch pressure control solenoid valve A/B assembly.
4. Clean the mounting surface and fluid passage of the A/T clutch pressure control solenoid valve A/B assembly and the transmission housing.
5. Place the new gasket on the transmission housing, then install the 8 mm ATF feed pipes (18 mm, 26 mm, 36 mm) with their filter side into the transmission housing.
6. Install the new O-rings over the feed pipes, and install the 8 x 40 mm ATF feed pipe.
7. Install the new A/T clutch pressure control solenoid valve A/B assembly and harness clamp bracket.
8. Check the A/T clutch pressure control solenoid valve connectors for rust, dirt, or oil then connect them securely.
9. Install the ATF cooler line (outlet line), and connect the ATF cooler hose to the cooler line.