Installation

INSTALLATION

CAUTION: Do not tap on the steering wheel or steering column shaft when installing the steering wheel.






1. Before installing the steering wheel, center the cable reel. Do this by first rotating the cable reel clockwise until it stops. Then rotate it counterclockwise approximately two turns. The arrow mark on the cable reel label should point straight up.






2. Install the steering wheel with the steering wheel bolt.

NOTE: Be sure the steering wheel shaft engages with the cable reel and canceling sleeve.

3. Attach the cruise control switch connector to the steering wheel clip.
4. Connect the horn connector.
5. Install the driver's airbag assembly, and confirm proper system operation. Refer to Air Bags and Seat Belts.
6. Check the horn and the cruise control switches for proper operation.