Brake Fluid Pump: Service and Repair

WARNING: The modulator unit contains high-pressure brake fluid Be sure to bleed the high-pressure fluid from the modulator unit before removing the pump motor.

- Bleed the high-pressure brake fluid from the modulator unit. Service and Repair

- Remove the modulator unit from the vehicle. Service and Repair

- Remove the 8 mm flange bolts from the modulator unit, and remove the pump motor.
- Install the pump motor in the reverse order of removal.

Specs:
Flange Bolt 15 Nm (11 lb.ft.)

NOTE:
- After installing the modulator unit, add fresh brake fluid until the reservoir is refilled to the specified level, and bleed air from the system. Service and Repair
- Turn the ignition switch ON (II), and check for the ABS indicator light operation.